Dana 44 Axle Identification Numbers

Dana 44 Axle Identification Numbers – The bill of material (bom) number is used to identify dana differentials. A vertically positioned tag near the center of the right hand side. The axle model number is cast in to the housing (30, 44, 60) either on the right (facing the axle cover) lower at the point where the axle tube is pressed in to the center section. Chevy & gmc front axle id.

Dana Rear Axle Identification Chart

The bill of material (bom) number is used to identify dana differentials. The bom will identify the model number, the gear ratio, the type of differential, and all component. Dana 44™/216 3.73 and down 3.92 and up dana 70™ 2ua 3.07 only — dana 44™/216 ica super 70™/273 none 4.10 and up 1984 & earlier 3.73 and down 3.92 and up dana.

It’s A Handy Skill To.

My friend has a 1960s ford pickup, and we can't identify the rear axle. 8.5 / 216mm pinion diameter /. Dana spicer off highway axles are identified with serial tags, tags that vary generation to generation or by production facility.

It's Either A Dana 44 Or A Dana 60.

How can we tell the difference?—ted olmstead, via. The dana 44 has been used on the front and rear of jeeps. It is like the vin number for your axle assembly.

8.5 / 216Mm Ring Gear Diameter:

Below is an illustration showing the common location. The results can be seen here. But how many of us can easily id a vehicle’s rear axle?

Spicer/Dana 44 Rear Axles Are Identified By A Casting Number Stamped Into The Bing On The Front Of The Differential Case To The Driver's Side Of The Driveshaft.

Below you'll find information to help you with dana 44 and dana 60 front axle identification covering a variety of makes and models. Seasoned car guys can often identify cars at first sight. Over the years, they've become more common on the rear than the front.

For Independent Front Suspension (Ifs) Axles, The B/M Number May Be Located At One Of Three Locations:

The bill of material (bom) number is used to identify dana differentials. The axle model number is cast in to the housing (30, 44, 60) either on the right (facing the axle cover) lower at the point where the axle tube is pressed in to the center section or in the nose of the housing near the. The bom will identify the model.